Sanguinololu complete kit v1.3a

New products

No new products at this time

Sanguinololu complete kit v1.3a

Send to a friend
Print
View full size

A complete Sanguinololu 1.3a board, including endstops, pullup resistors and cabling for them. We have included Pololu A4988 stepper drivers by default, but they are optional.

This kit comes unassembled, however assembly can be done completely or just the SMD part. Assembly is made to order, we do not keep assembled stock.

See below for complete contents.

More details

Customers who bought this product also bought:

In the same category

More info
Comments (0)

Complete contents of this kit are:

Sanguinololu PCB v1.3a
Sanguinololu components for PCB v1.3
4 x Pololu A4988 Stepper drivers (optional, but needed for a working solution!)
3 x Microswitches (end stops)
Cabling for the microswitches (3 x 30cm, with connector in place)
3 x 10k resistor ( 1% metal film) in case your firmware doesn't support the internal pullups of Arduino

Offcourse, the microprocessor (an Atmel ATMEGA644p) is flashed with the Arduino bootloader, so it's ready for use. You will have to upload your choice of firmware before it functions in your printer using the Arduino GUI.

There are two possible ways to connect a Sanguinololu: Using 12 ATX or a screw terminal. This kit contains components for both!

No customer comments for the moment.

Only registered users can post a new comment.