Welcome Log in
--Price: lowest firstPrice: highest firstProduct Name: A to ZProduct Name: Z to AIn-stock first Sort by
This thickplate is used to mount the upper thickplate on, and is made out of 4mm MDF
This 225x225mm aluminum printbed is 3mm thick. Just enough to make sure it doesnt start bending should your printhead hit the plate, but also still very possible to use as a heated printbed! You can use this thickplate as upper thickplate on a traditional Prusa/Mendel design, but also as the only thickplate on a single-board design (Prusa...
A set of 4 springs, needed to mount your printbed onto the lower thickplate, or for use in an extruder.
This 140x225mm aluminum printbed is 3mm thick and is a replacement of the MDF lower thickplate, just a bit more sturdy. TODO: Update pictures
A complete heated printbed kit, including:Heated printbed PCB MK2 (http://reprap.org/wiki/PCB_Heatbed) Needed LED's for indication of operation A thermistor (G550, for specs check out our thermistor) A resistor (1kOhm) Polyamide heat conducting tape...
Heated printbed PCB MK2 (http://reprap.org/wiki/PCB_Heatbed). A 215x215mm PCB with heat resistant copper traces, ready to put/screw/mount on an upper thickplate! This product is obsolete. It has been succeeded by V2
A complete heated printbed kit, including:Heated printbed PCB MK2b, for 12V and 24V (http://reprap.org/wiki/PCB_Heatbed) A thermistor (G550, for specs check out our thermistor) Polyamide heat conducting tape (Kapton), roll of 24mm wide
Heated printbed PCB MK2B (http://reprap.org/wiki/PCB_Heatbed). This edition has options for both 12V and 24V operation, allowing faster heating and safer working environments due to lower currents. A 215x215mm PCB with heat resistant copper traces, ready to put/screw/mount on an upper...
A roll of kapton, 24mm wide, 33 meters long.
No products
Shipping € 0,00 Total € 0,00
Cart Check out
» All new products
Follow us